ERIKC denso 294009-0230 diesel injector meterring SCV valve A6860-EC09A oil pump suction control valve SM294009-0251
Product Introduction
For engine:
294009-1110 294000-041# Nissan Cabstar 3.2 TDCi 2003-2010
294009-0251 294000-042# Nissan Navara 2.5 dCi
294009-0250 294000-062# Nissan Pathfinder 3.0 dCi
0360 02Q18 294000-064# L200 KA4T 2.5 dCi 2005-2016
2003-2016
1460A037 294000-066# PAJERO V88W 4.0 4WD 2005-2016
294009-02514 (V80, 90) 3.0 dCi
294009-1110 294000-095# MAZDA DIESEL 6 2.0L
294000-0400 294000-053# Nissan 4D56
294000-0402 294000-0501 LIGHT TRUCK 4M41
294000-023# 294000-0502 & PASSENGER YD 25DDTI
294000-033# 294000-034# PAJARO 4M41
Product Picture
| Denso Metering Valve |
| 294200-0170 |
294000-0167 |
294200-0300 |
294200-0360 |
| 294009-0230 |
294009-0370 |
294200-0301 |
294009-0260 |
| 294200-0190 |
294200-0160 |
|
|
294200-2760
294200-4760
294009-0741 |
04226-0L010
04226-0L020
04226-30010
22560-30020
294200-0093
294200-0040
294200-0042
294009-0660
|
|
|
ERIKC hot product
Mainly producing and selling CR injectors, nozzles, control valves, valve bonnets, CRIN repair kits, injector adjusting shims, common rail injector testers and repair tools. Besides our own brand "HAOTENG" and "DYD", we are also the sole agent of UK ERIKC (the former OEM factory of famous international brand common rail Parts).
Injector FAQ
FAQ: Judging method of rail pressure sensor
ERIKC Answer: The rail pressure sensor (CRPS) is a piezoresistive type and has three terminals. CRPS terminals 1# are ground wires, 2# terminals are signal lines, and 3# terminals are power lines (5V).
The resistance between the two terminals of the three terminals of the sensor can be measured with the resistance of the multimeter to determine whether the sensor is good or bad.
FAQ: sensor voltage measurement
ERIKC Answer: Unplug the rail pressure sensor plug, measure the sensor side plug, the voltage between terminal 3 and ground should be 5V, the voltage between terminal 2 and ground should be about 5V, and the voltage between terminal 1 and ground is 0V. Connect the plug and the voltage between the three terminals is 5V, 0.5V, 0V.
FAQ: data flow detection
ERIKC Answer: Reading the engine system data stream with the diagnostic tool, there are 4 data streams involving the rail pressure: "fuel system rail pressure", "rail pressure setting value", "actual rail pressure maximum value", "rail pressure sensor output Voltage".
