ERIKC F00VC01376 bosch injector pressure safety valve F 00V C01 376 dieseloil oil valve seal F00V C01 376 For 0445110338

ERIKC F00VC01376 bosch injector pressure safety valve F 00V C01 376 dieseloil oil valve seal F00V C01 376 For 0445110338

Valve Introduction

bosch common rail original injector

Valve Picture

Other ERIKC Valve List

ERIKC hot product

Mainly producing and selling CR injectors, nozzles, control valves, valve bonnets, CRIN repair kits, injector adjusting shims, common rail injector testers and repair tools. Besides our own brand we are also the sole agent of UK ERIKC (the former OEM factory of famous international brand common rail Parts).

Injector FAQ

FAQ: What is Injector Duty Cycle?

ERIKC Answer: To control the amount of fuel that enters the engine the injectors are turned on and off or pulsed very quickly. The amount of time an injector is turned on to deliver fuel is known as the duty cycle. This is measured as a percent, so 50% duty cycle indicates that the injector is held open and held closed for an equal amount of time. When the engine needs more fuel, the time that the injector stays on (its duty cycle) increases so that more fuel can flow into the engine. If an injector stays on all the time, it is said to be static (wide open, or 100% duty cycle).

FAQ: What does the term static means?

ERIKC Answer: If an ERIKC injector stays on all the time, 100% duty cycle, it is said to be static. Injectors should never go static because control of fuel delivery is lost and this can cause catastrophic engine failure. Static injectors, or 100% IDC is normally an indication that the injector is too small for the engine. Injector duty cycle should usually not exceed 80%. Once 80% IDC is reached a bigger injector should be installed.

In some instances low fuel pressure or a failing fuel pump can cause injectors to become static. On the other hand, there are some injectors that will go static if the fuel pressure is too high.